MTP 15HD A Series • Setup Guide
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and audio transmission
systems.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.
Step 2 — Transmitter Inputs
AUDIO
INPUT
•
•
•
Connect a computer (VGA) video source to the Input connector.
Connect a VGA monitor to the Monitor connector.
Plug a 3.5 mm stereo audio plug into the audio jack.
MONITOR
Step 3 — TP Cables Between Units
•
Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and
the receiver’s Input port.
T568A
Pin Wire color
T568B
Pins:
12345678
Wire color
1
White-green
Green
White-orange
Orange
NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.
2
3
4
5
White-orange White-green
•
For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered Output port
and a daisy-chained receiver’s Input port.
Blue
Blue
White-blue
White-blue
6
7
8
Orange
Green
Step 4 — Receiver Outputs
Insert Twisted
Pair Wires
White-brown
Brown
White-brown
Brown
•
•
Connect a VGA monitor to the Output connector.
Connect a mono audio device to the Mono Audio connector. Wire the connectors as shown
below.
NOTE: If you are using Enhanced Skew-Free™ AV
cable, use the TIA/EIA T568A standard only.
MONO AUDIO
ATTENTION: Connect the sleeves to ground (Gnd).
1
2
Connecting the sleeve to a negative (-) terminal will damage the audio
output circuits.
Mono output 1+
Mono output 1-
Sleeve(s)
Mono output 2+
Mono output 2-
Mono output 1
NO GROUND.
Sleeve(s)
Mono output 2
NO GROUND.
OUTPUT
Do not tin the wires!
Balanced Output
Unbalanced Output
Step 5 — Receiver DIP Switches
•
•
H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.
Composite Sync, (SOG), and Video switches — Set these switches as shown in the table below to
output the indicated format.
ON
1
2
3
4
5
6
Output Format
RGBHV
C Sync
SOG
Video
RGBS
RGsB
Component*
S-Video*
Composite*
NOTE: * Input video format must match.
•
End Unit switch — Set this switches up if either of the following is true:
•
•
The receiver being configured is the only receiver connected to the transmitter.
The receiver being configured is the last receiver in a daisy-chained system.
|
Cisco Systems Network Hardware OL 12812 01 User Manual
Craftsman Chipper 247797855 User Manual
Craftsman Dust Collector SP5373 User Manual
Curtis Portable DVD Player DVD1044 User Manual
CyberHome Entertainment DVD Player CH DVD500 User Manual
Eagle Electronics Portable Radio EVR 150 User Manual
Electro Voice Portable Speaker MTS 1 User Manual
Fisher Price Cell Phone X14969 User Manual
Fundex Games Games 2729 User Manual
GE Oven 164D2966P126 User Manual